You need not be an expert artist to make easy leather leather crafts. You can recycle and create simple crafts leather boots. Like most shoes, the ground and the toe is spent and you can only leather that covers the legs. Cowboy boots, leather boots with zipper on one side and to the soft leather boots that have intricate designs, are great candidates for simple leather crafts.

Instructions

Musings cowboy boot

1
Located in flat cowboy boot on a cutting board. It is 8 inches (20 cm) down from the edge top or the depth you want to catch. Mark the measurements with a pencil on one side of the boot. Locate a rule through the boot on the pencil line. Using the ruler as a straight edge, cut along the line with a knife. Repeatedly passes through the deepening line on each pass until the top of the boot is separated from the bottom.

leather boots

2
A rule located in the bottom of the cut of the leg , one-half inch (1.75 cm) from the bottom. On the edge of the ruler, makes a point with a pencil every half inch (1.25 cm) by the width of the boot. Locate the leg of the boot in a cut of wood to protect your work surface. Make a hole with a small tip at each marked point. The drilled holes should penetrate both sides of the boot.

 
3
Cut a piece of craft wire 36 inches (90 cm) using wire cutters. Insert one end of the wire through the first hole on the edge of the boot and the hole that corresponds to the other side. Push the wire 1 ½ inches (3.75 cm). Board and this small piece is left over on the opposite side of the boot. Fold the wires to each other to connect the cut edge of the boot.

4
Insert the long piece of wire through the next hole, from the front to back. Bring the wire to the front and insert it into the next hole. Continue in this fashion, sewing the cut end of the boot and creating a pouch. Threaded wire again with some stitches and cut the excess wire.

5
Cut 18 inches (45 cm) packed rusty wire. Inserting one end of the wire, about 2 inches (5 cm) through the hump on one of the upper edges of the boot. Fold one edge of two inches (5 cm) in a small hump using tweezers. Insert the other end by the hump and turn left creating a handle for drawer tailor. Hang drawer tailor in a hook to organize your space.

Leather paper weights

1
Cut four squares five inches (12.5 cm) leather boots women. The leather of these boots is generally thin and easy to cut with scissors.

2
Locate one of the square down on your desk. Applies a glue line on the three edges. Locate another square right up in the square by matching the edges. Press the squares. Let the glue dry.

3
Use a stencil alphabet 1 inch long (2.5 cm) and a brush to write the word “IN” on the square top using gold acrylic paint. Let the paint dry.

4
Open without hitting the edge of the squares glued half spilled cup of dried beans. Apply a line of glue on the inside edge open. Press edges together to secure the brooches. Let the glue dry and remove the pins.

5
Repeat steps using the other two squares and applying stencil the word “NOT” in the box above .